* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Download ELG3336 - Remote Controlled Boat
History of electric power transmission wikipedia , lookup
Opto-isolator wikipedia , lookup
Switched-mode power supply wikipedia , lookup
Mains electricity wikipedia , lookup
Electric machine wikipedia , lookup
Power engineering wikipedia , lookup
Voltage optimisation wikipedia , lookup
Electrification wikipedia , lookup
Alternating current wikipedia , lookup
Electric motor wikipedia , lookup
Potentiometer wikipedia , lookup
Brushless DC electric motor wikipedia , lookup
Induction motor wikipedia , lookup
Brushed DC electric motor wikipedia , lookup
Stepper motor wikipedia , lookup
Group B01 Tarek Yakub – 4133137 Fahad Aljenaei – 4290975 Danish Qureshi - 417235 Project Background  Major Electrical Components  Pulse Width Modulation (PWM)  Remote Control  Potentiometer  Major Mechanical Components  Creating a body that can float on water  Fans to propel boat forward PWM (IC 555 timer)  How it works?  Uses square voltage pulses that power a motor  The amount of power applied to the motor depends on the duration of each pulse  The higher the duration of the pulses results in an increased average power applied to the motor  Theoretical Circuit  Actual Circuit & Connection The Boat  The boat was made out of swimming noodles held together using metal bars  Holes were drilled through a piece of wood to hold the motors in place and mounted on the boat using metal brackets and screws Propulsion  The boat is powered by two computer fans which have been attached to the output shafts of 6V motors  By adjusting the potentiometer, the boat is able to move forward at variable speeds.  By varying the speed of one motor at a time allows the boat to turn left or right The Boat in Motion  This video shows the boat slightly turning right and left, as well as slowing speed while moving forward Complications  Building the circuit  Low voltages across the motor  Not enough current going into the motor  Solutions to these problems  Changed one of the capacitors and removed one of the resistors  To deliver the proper amount of current into the motor (1.8 A)  Changed Potentiometer (from 100 kOhms, to 10 kOhms because resistance was to high)  This was found through trial and error (at 100 kOhms the current was 428 mA, at 10 kOhms the current was 2.4 A, 6 times greater!)  Used multi-sim to aid in problem solving  Choosing a PWM over the variable resistor due to heating up and also make use of IC 555 timer as we learned Improvements/Modifications  Larger Fans  More powerful motors  To increase speed  Place the fans further apart  To allow the boat to turn easier  Wireless control Thank You
 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
									 
                                             
                                             
                                             
                                             
                                             
                                             
                                             
                                             
                                             
                                             
                                            