• Study Resource
  • Explore
    • Arts & Humanities
    • Business
    • Engineering & Technology
    • Foreign Language
    • History
    • Math
    • Science
    • Social Science

    Top subcategories

    • Advanced Math
    • Algebra
    • Basic Math
    • Calculus
    • Geometry
    • Linear Algebra
    • Pre-Algebra
    • Pre-Calculus
    • Statistics And Probability
    • Trigonometry
    • other →

    Top subcategories

    • Astronomy
    • Astrophysics
    • Biology
    • Chemistry
    • Earth Science
    • Environmental Science
    • Health Science
    • Physics
    • other →

    Top subcategories

    • Anthropology
    • Law
    • Political Science
    • Psychology
    • Sociology
    • other →

    Top subcategories

    • Accounting
    • Economics
    • Finance
    • Management
    • other →

    Top subcategories

    • Aerospace Engineering
    • Bioengineering
    • Chemical Engineering
    • Civil Engineering
    • Computer Science
    • Electrical Engineering
    • Industrial Engineering
    • Mechanical Engineering
    • Web Design
    • other →

    Top subcategories

    • Architecture
    • Communications
    • English
    • Gender Studies
    • Music
    • Performing Arts
    • Philosophy
    • Religious Studies
    • Writing
    • other →

    Top subcategories

    • Ancient History
    • European History
    • US History
    • World History
    • other →

    Top subcategories

    • Croatian
    • Czech
    • Finnish
    • Greek
    • Hindi
    • Japanese
    • Korean
    • Persian
    • Swedish
    • Turkish
    • other →
 
Profile Documents Logout
Upload
A Routing Protocol for k
A Routing Protocol for k

... A Routing Protocol for k-hop Networks ...
T201xxxx MM7 – Use Cases, Goals and Requirements
T201xxxx MM7 – Use Cases, Goals and Requirements

... attempts RFC822-style addressing for applications (applicationname@server-name.operator-domain.toplevel-domain) Submit / Deliver operations VASP controls basic service charging VASP should get individual „low-credit“ or „no-credit“ result codes for push messages to prepaid subscribers Support of rev ...
File
File

... Copyright © 2009 Pearson Education, Inc. Publishing as Prentice Hall ...
The Transport Layer - CIS @ Temple University
The Transport Layer - CIS @ Temple University

... network. The end-user cannot control what is in the network. So the end-user establishes another layer, only at end hosts, to provide a transport service that is more reliable than the underlying network service. 2. While the network layer deals with only a few transport entities, the transport laye ...
Slides
Slides

...  client-client connection: direct (not through server) Instant messaging  chatting between two users is P2P  centralized service: client presence detection/location • user registers its IP address with central server when it comes online • user contacts central server to find IP addresses of budd ...
Anue 5200 Series Net Tool Optimizer
Anue 5200 Series Net Tool Optimizer

... You can either use TACACS+ or local authentication for NTO user accounts. As an Anue NTO administrator, you can control which types of ports, monitoring tools and filters are accessible to a particular group or individual user. This fine-grained access control ensures that only the people who need ...
Managed Switch Quick Start Guide
Managed Switch Quick Start Guide

... • HiperRing: Turn ON the RM (redundancy manager) DIP switch on exactly ONE of the switches in the network (on MICE, also turn ON DIP switch 4/Configuration). Daisy chain the switches’ ring ports together and then connect the last switch to the first to create a ring. No software configuration change ...
3rd Edition: Chapter 4
3rd Edition: Chapter 4

... security: all OSPF messages authenticated (to prevent malicious intrusion) multiple same-cost paths allowed (only one path in RIP) for each link, multiple cost metrics for different TOS (e.g., satellite link cost set “low” for best effort ToS; high for real time ToS) integrated uni- and multicast su ...
Chapter 2 - William Stallings, Data and Computer
Chapter 2 - William Stallings, Data and Computer

... network-level address – The network-level address is used to route a PDU through a network or networks to a system indicated by a network level address in the PDU. – Once data arrive at a destination system, they must be routed to some process or application in the system. – Typically a system suppo ...
$doc.title

... Local version of EVRYTHNG’s Reactor™ Rules Engine ...
CSC 311 - School of Computing Homepage
CSC 311 - School of Computing Homepage

... Link state routing: • Each node communicates what it knows to its neighbors 1. bit rate 2. delay 3. queue length 4. reliability • a node builds a link state packet for each link • nodes receiving link state packets forward them to neighbors • as these packets are exchanged , nodes learns about the n ...
Quantifying disincentives in P2P Systems
Quantifying disincentives in P2P Systems

... (Courtesy: http://computer.howstuffworks.com/file-sharing.htm) ...
Healthcare Monitoring System Using Wireless Sensor Network
Healthcare Monitoring System Using Wireless Sensor Network

... SMS server to send a confirm acknowledgment when the SMS was received by the target. A time counting program was plugged into the gateway to count the delay time of Ethernet data packages and SMS transmissions. The time counting result was saved in an onboard file. The remote server was connected wi ...
CCNA4E_CH8_STUDY_GUIDE
CCNA4E_CH8_STUDY_GUIDE

... Describe the Network Configuration Table. What data set should be included for all components? Describe the End-system Configuration Table. For troubleshooting purposes, what information should be documented? Describe the Network Topology Diagram. At a minimum, the topology diagram should include wh ...
Chapter_5_V6.01
Chapter_5_V6.01

... Link layer, LANs: outline 5.1 introduction, services 5.5 link virtualization: MPLS 5.2 error detection, correction 5.6 data center networking 5.3 multiple access protocols 5.7 a day in the life of a web request 5.4 LANs ...
Appendix C Command Line Reference
Appendix C Command Line Reference

... This section describes how to use CLI commands to configure the access point and how to view system settings and information. Table C-3 shows the commands available at the blank CLI prompt. You can type TAB twice to display the list of commands. After you enter the command, press the TAB key twice t ...
Virtual Router VPN Architecture
Virtual Router VPN Architecture

... Routing for each VPN is the same as regular network routing The choice of the backbone protocols is not constrained by the VPNs and vise versa No protocol modifications needed No tool (debugging, management,etc.) modifications needed Deployment will not impact normal operation of the provider networ ...
MCITP Guide to Microsoft Windows Server 2008 Server Administration
MCITP Guide to Microsoft Windows Server 2008 Server Administration

... Settings are stored in group policy objects (GPO) GPOs can be local and nonlocal Can be set up to affect user accounts and computers When group policy is updated: • Old policies are removed or updated for all clients ...
Average power consumption breakdown of Wireless Sensor
Average power consumption breakdown of Wireless Sensor

... designed specially for WSN. It provides a REST-like interface [11] on top of the UDP transport layer, but with a lower cost than HTTP-based REST interfaces. Table I shows the analyzed network protocols’ stack in this work, which is among the most widely used in WSN. Almost every layer is standardize ...
Hands-On Ethical Hacking and Network Security
Hands-On Ethical Hacking and Network Security

... access large number of ports, in close sequence, on single host, in short time  TCP session initiated to IP address, immediately terminated, not followed by additional communication, observable in firewall log  TCP session only half set up then abandoned, potentially observable in firewall log ...
Wireless & Mobile Technologies
Wireless & Mobile Technologies

... other wireless technologies in the range of service, network capacity and data bit transfer rate.  Designed to operate over a much smaller service area.  Devices that participate in these types of peer based networks are designed to automatically discover other devices and services.  Connects per ...
Slides 2 - USC Upstate: Faculty
Slides 2 - USC Upstate: Faculty

...  route computation using Dijkstra’s algorithm ...
WDRM, 2nd edition - Falcon Electronics
WDRM, 2nd edition - Falcon Electronics

... in connection with microwave horn antennas and waveguides. 2. The physical size of the opening in a camera lens, expressed as F-stops. application address An address used to uniquely identify each software process running on a network device. See medium access control (MAC)address and network addres ...
Dell Networking S4810 Data Sheet
Dell Networking S4810 Data Sheet

... The Dell Networking S-Series S4810 is an ultra-low-latency 10/40GbE switch purpose-built for applications in highperformance data center and computing environments. Leveraging a non-blocking, cut-through switching architecture, the S4810 delivers line-rate L2 and L3 forwarding capacity with ultra lo ...
NETWORK TRANSFORMATION WITH SOFTWARE DEFINED
NETWORK TRANSFORMATION WITH SOFTWARE DEFINED

...  Applying network research results, prototypes, and emerging innovations to enable (identified) research and education  May leverage new and existing investments in network infrastructure, services, and tools by combining or extending capabilities to work as part of the CI environment used by scie ...
< 1 ... 175 176 177 178 179 180 181 182 183 ... 592 >

Zero-configuration networking

Zero-configuration networking (zeroconf) is a set of technologies that automatically creates a usable computer network based on the Internet Protocol Suite (TCP/IP) when computers or network peripherals are interconnected. It does not require manual operator intervention or special configuration servers.Zeroconf is built on three core technologies: assignment of numeric network addresses for networked devices, automatic distribution and resolution of computer hostnames, and automatic location of network services, such as printing devices. Without zeroconf, a network administrator must set up services, such as Dynamic Host Configuration Protocol (DHCP) and Domain Name System (DNS), or configure each computer's network settings manually.
  • studyres.com © 2025
  • DMCA
  • Privacy
  • Terms
  • Report